Processing process of LED lamp accessories


Release Time:

2022-09-30

LED lamp accessories include light sources, terminals, sensors, converters, adapters, light boxes, acrylic accessories, plastic accessories, special lamps, electronic components, capacitors, brackets

Processing process of LED lamp accessories

LED lamp accessories
LED lamp accessories include light sources, terminals, sensors, converters, adapters, light boxes, acrylic accessories, plastic accessories, special lamps, electronic components, capacitors, brackets
Assembly of LED ceiling spotlight accessories
1. The lamp face ring is equipped with spring buckles on both sides.
2. The terminal wire passes through the radiator and the light source board, and the welding wire is ready.
3. Welding wire, blue wire negative pole "-" brown wire positive pole "+".
4. Rub the back of the light source plate with thermal conductive silicone grease, which must be used for heat dissipation.
5. Install the lens and screw it with the middle ring.
6. Insert the face ring and tighten the screws. One screw on each side is not very tight.
7. At this time, the installation of LED ceiling spotlights is basically completed.
8. Connect the drive power terminal interface.
9. Connect the wires. When connecting the wires, be sure to turn off the switch to avoid electric shock. In the picture, I took a photo on the workbench. Quick terminal
In fact, the processing method of LED lamps is not very difficult. Different LED lamps have slightly different assembly methods. As long as we believe we can learn how to do it quickly according to the correct method, we can assemble LED lamps by ourselves. I hope the introduction made by the editor will be helpful.

Key words:

LED